Owon TDS Series Manual de usuario Pagina 19
- Pagina / 82
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
4.Junior User Guidebook
14
How to Use the Probe Safely
The safety guard ring around the probe body protects your finger against any electric
shock, shown as Figure 4-9.
Figure 4-9 Finger Guard
Warning:
To avoid electric shock, always
keep your finger behind the safety guard
ring of the probe during the operation.
To protect you from suffering from the electric shock, do not touch any
metal part of the probe tip when it is connected to the power supply.
Before making any measurements, always
connect the probe to the
instrument and connect the ground terminal to the earth.
How to Implement Self-calibration
The self-calibration application can make the oscilloscope reach the optimum
condition rapidly to obtain the most accurate measurement value. You can carry out
this application program at any time. This program must be executed whenever the
change of ambient temperature is 5℃ or over.
Before performing a self-calibration, disconnect all probes or wires from the input
connector. Press the "Utility" button, select Calibrate in the left menu, select Self
Calibrate in the bottom menu. A confirmation window will pop up, select OK after
everything is ready.
Introduction to the Vertical System
As shown in Figure 4-10, there are a few of buttons and knobs in VERTICAL
CONTROLS. The following practices will gradually direct you to be familiar with
the using of the vertical setting.
- TDS Series 1
- User Manual 1
- July 2013 edition V1.0 2
- Headquarter: 2
- Branch: 2
- General Warranty 3
- Table of Contents 4
- Safety Terms 7
- Safety Symbols 7
- Warning: 8
- 3. General Characteristics 9
- 4. Junior User Guidebook 10
- Front Panel 11
- Rear Panel 12
- Touch to select the channel 23
- Press repeatedly to 26
- 4.Junior User Guidebook 27
- 5. Advanced User Guidebook 28
- Using FFT function 32
- Information of 35
- Zoom the Waveform 36
- Trigger Control 37
- 2. Video Trigger 38
- 3. Pulse Width Trigger 38
- 4. Slope Trigger 39
- Threshold 40
- &SlewRate 40
- Persist 44
- XY Mode 44
- How to Save and Recall 45
- To save setup files 47
- To recall setup files 48
- To edit file names 48
- To manage file 49
- ●Config 50
- ●Display 50
- ●Calibrate 51
- ●Pass/Fail 51
- ●Sync Output 53
- ●System 53
- Measure 54
- Rise Time 56
- Fall Time 56
- How to Use Autoscale 61
- Autoset 62
- 6. Communication with PC 64
- Using LAN Port 65
- Connect through a router 66
- Touch to complete the 68
- 7. Demonstration 69
- 8. Troubleshooting 77
- 10. Appendix 82
Relacionado con productos y manuales para Instrumentos de medición Owon TDS Series
(112 paginas)Trex SDPFC050509 manuals
Owner’s manuals and user’s guides for Circular saws Trex SDPFC050509.
We providing 1 pdf manuals Trex SDPFC050509 for download free by document types: Installation Guide
Comentarios a estos manuales