
Slope Trigger
Slope trigger sets the oscilloscope as the positive/negative slope trigger within the
specified time.
The Slope Trigger Menu is shown as Fig. 5-22.
Fig. 5-22 Slope Trigger menu
Slope Trigger menu list
Source
Channel 1 as the trigger source.
Channel 2 as the trigger source.
Slope
When
Set slope condition
Settings
24ns~10s
Turn "TRIG LEVEL" knob to set slope time
Turn "TRIG LEVEL" knob to set the High level
Low level
Turn "TRIG LEVEL" knob to set Low level
Slew rate=( High level- Low level)/ Settings
Trigger
mode
Normal
Single
Acquire waveform whatever detect trigger condition or not
Only acquire waveform when match trigger condition
Only acquire waveform for single time when detect trigger
Holdoff
~
Set interval by using TRIG LEVEL control, value range from
100ns
~
Reset hold time to 100ns
Alternate trigger
Trigger signal comes from two vertical channels when alternate trigger is on. This
Comentarios a estos manuales