
Alternate trigger(Trigger Type: Pulse) menu list
Source
Channel 1 as the trigger source.
Channel 2 as the trigger source.
when
(+pulse width less than )
(+pulse width more than )
(+Pulse width equal to)
(-Pulse width less than)
(-Pulse width more than)
To select pulse width condition
settings
24ns~10s
Turn "TRIG LEVEL" knob to set time
Coupling
DC
HF
LF
Block the direct current component.
Unblock all components.
Block the high-frequency signal and only
unblock the low-frequency component.
Block the low-
frequency signal and only
unblock the high -frequency component.
Holdoff 100ns~10s
Set interval by using TRIG LEVEL
control, value range from 100ns
~
Reset hold time to default value (100ns).
Alternate trigger(Trigger Mode: Slope )
Alternate trigger(Trigger Type: Slope )Menu is shown as Fig.5-26.
Fig.5-26 Alternate trigger(Trigger Type: Slope )Menu
Alternate trigger(Trigger Type: Slope) menu list:
Source
S
elect CH1 as the trigger source.
Select CH2 as the trigger source.
Rising Edge and more than.
Comentarios a estos manuales